CADD Technology
	
	We provide engineers, designers and drafters the tools to simplify the design
	and drafting processes of mechanical piping systems. Tubero CADD Technology offers third party
	applications that complements MicroStation ®, Registered trademark of Bentley Systems International.
	
		Minimum Requirements:
		Tubero Ortho piping application requires MicroStation ® V8 or later.

		Downloading and installing the application:
		1. Download Tubero Products from  http://www.tubero.com
		2. Click the desired application to download.

		Installing on the fly:
			◦ Click the Open button and double click the mirrored executable file in your Temporary Internet File directory.
			◦ Click the Run button and let the DigitalWeb InstallWizard takes over (continue on #3).

		Installing by saving the file:
			◦ Click the Save button and save the zip file into your temporary download directory.
			◦ Go to your temporary download directory and do either of the following:
				• Right click the dowloaded zip file and select extract all, click next, next, and finish (continue on #3).
				• Go to the extracted file directory and double click the executable file (continue on #3).
				• Or double click the downloaded zip file, click the Run button and let the DigitalWeb InstallWizard takes over (continue on #3).

		3. The Install Wizard will unpack the application package and prepare the required installation process.
		4. Click the next button, read and hi-lite the Accept button when the License Agreement appears and click the next button again.
		5. It's preferrable to click the next button once the Destination Folder appears to avoid editing tubero.cfg later on.
		6. Select Typical setup type and click the next button.
		7. Click Finish to dismiss the DigitalWeb InstallWizard dialog box.

		Loading the application:
		1. Load by key-in mdl load[drive]/[program files]/ Tubero/Program/*****.ma
		2. Or via MicroStation ® Utilities pulldown menu, mdl applications, browse [drive]/[program files]/Tubero/Program/*****.ma.

		Important Reminder:
		1. Entities are created and graphically grouped together.
		2. To preserve the MTO attributes integrity, make sure that the graphic group is in lock on position when deleting entities.
		3. Also, when performing entity manipulation, be sure the graphic group is in lock on position as well.
		4. To create non-reportable entity, set the MTO toggle button to OFF.
		5. The rubber band effect does not apply to entities being placed with the conditional third directional data point, i.e., flat turn tees, elbows, etc.
		6. Tubero Ortho rolled fitting angle range is from 1 to 60 degrees only.
		7. Tubero Ortho Valve Assembly Mode does not apply to 3 and 4 way valves, angle and relief valves.
		8. Tubero Ortho dialog boxes are provided for both IMPERIAL and METRIC working units.
		9. For the Tubero Ortho application, if the dimension needed is not found in the database, the user is prompted for interactive variable input.
		10. Some commands are transparent, i.e., they are in repetitive mode. Hit reset/cancel button to exit out of the transparent mode.
		11. Error messages are sent to the users when invalid input has occurred.